2017-08-09新疆精河Ms6.6地震附近区域相对应变的变化分析     

高丽娟  邢喜民  高歌  李尚伟 《大地测量与地球动力学》2019,39(10):1002-1006

2017年精河M_S6.6地震震前，尼勒克、巴伦台和小泉沟台钻孔应变仪记录到显著的应变变化，经现场落实确认，异常是可靠的。根据这3个台的记录资料计算相对应变的变化，结果表明，地震前最大（小）主应变大小和方向分别出现明显加速和急剧偏转变化。此外还发现，相对应变场异常期间主方向与震源机制解P轴方位较为一致。  相似文献   

Modelling the effect of changing precipitation inputs on deep soil water utilization          下载免费PDF全文

Ji Qi  Daniel Markewitz  David Radcliffe 《水文研究》2018,32(5):672-686

Forests in the Southeastern United States are predicted to experience future changes in seasonal patterns of precipitation inputs as well as more variable precipitation events. These climate change‐induced alterations could increase drought and lower soil water availability. Drought could alter rooting patterns and increase the importance of deep roots that access subsurface water resources. To address plant response to drought in both deep rooting and soil water utilization as well as soil drainage, we utilize a throughfall reduction experiment in a loblolly pine plantation of the Southeastern United States to calibrate and validate a hydrological model. The model was accurately calibrated against field measured soil moisture data under ambient rainfall and validated using 30% throughfall reduction data. Using this model, we then tested these scenarios: (a) evenly reduced precipitation; (b) less precipitation in summer, more in winter; (c) same total amount of precipitation with less frequent but heavier storms; and (d) shallower rooting depth under the above 3 scenarios. When less precipitation was received, drainage decreased proportionally much faster than evapotranspiration implying plants will acquire water first to the detriment of drainage. When precipitation was reduced by more than 30%, plants relied on stored soil water to satisfy evapotranspiration suggesting 30% may be a threshold that if sustained over the long term would deplete plant available soil water. Under the third scenario, evapotranspiration and drainage decreased, whereas surface run‐off increased. Changes in root biomass measured before and 4 years after the throughfall reduction experiment were not detected among treatments. Model simulations, however, indicated gains in evapotranspiration with deeper roots under evenly reduced precipitation and seasonal precipitation redistribution scenarios but not when precipitation frequency was adjusted. Deep soil and deep rooting can provide an important buffer capacity when precipitation alone cannot satisfy the evapotranspirational demand of forests. How this buffering capacity will persist in the face of changing precipitation inputs, however, will depend less on seasonal redistribution than on the magnitude of reductions and changes in rainfall frequency.  相似文献   

A novel coupled FDM-DEM modelling method for flexible membrane boundary in laboratory tests     

Hua-Xiang Zhu  Zhen-Yu Yin  Qiang Zhang 《国际地质力学数值与分析法杂志》2020,44(3):389-404

Difficulties are involved in discrete element method (DEM) modelling of the flexible boundary, that is, the membranes covering the soil sample, which can be commonly found in contemporary laboratory soil tests. In this paper, a novel method is proposed wherein the finite difference method (FDM) and DEM are coupled to simulate the rubber membrane and soil body, respectively. Numerical plane strain and triaxial tests, served by the flexible membrane, are implemented and analysed later. The effect of the membrane modulus on the measurement accuracy is considered, with analytical formulae derived to judge the significance of this effect. Based on an analysis of stress-strain responses and the grain rotation field, the mechanical performances produced by the flexible and rigid lateral boundaries are compared for the plane strain test. The results show that (1) the effect of the membrane on the test result becomes more significant at larger strain level because the membrane applies additional lateral confining pressure to the soil body; (2) the tested models reproduce typical stress and volumetric paths for specimens with shear bands; (3) for the plane strain test, the rigid lateral boundary derives a much higher peak strength and larger bulk dilatation, but a similar residual strength, compared with the flexible boundary. The latter produces a more uniform (or ‘diffuse') rotation field and more mobilised local kinematics than does the former. All simulations show that the proposed FDM-DEM coupling method is able to simulate laboratory tests with a flexible boundary membrane.  相似文献   

Character and origin of De Geer moraines in the Seacoast region of New Hampshire,USA          下载免费PDF全文

Samantha N. Sinclair  Joseph M. Licciardi  Seth W. Campbell  Brian M. Madore 《第四纪科学杂志》2018,33(2):225-237

  相似文献   

Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials          下载免费PDF全文

Chao Jiang  Gao‐Feng Zhao 《国际地质力学数值与分析法杂志》2018,42(4):674-693

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.  相似文献   

鄂尔多斯地块周缘垂直形变场负位错反演与应变积累研究     

张希  刘立炜  郝明  白卓立 《大地测量与地球动力学》2019,39(6):551-556

利用鄂尔多斯地块及其周缘1970～2014年的垂直形变速率场资料，借助负位错反演研究该区域长期应变积累。结果表明，地块东北缘山西断陷带中北段年均能量积累增量、剪应力强度都较高，西南缘六盘山断裂与渭河断裂西段次之；山西断陷带中南段至晋陕交界处年均剪应力强度较高且显示一定程度的能量积累；西秦岭构造区尤其西秦岭北缘断裂西段、晋冀蒙交界区也反映一定程度的能量积累特性。  相似文献   

Dynamic modelling of retrogressive landslides with emphasis on the role of clay sensitivity          下载免费PDF全文

Xue Zhang  Scott W. Sloan  Eugenio Oñate 《国际地质力学数值与分析法杂志》2018,42(15):1806-1822

This paper presents a detailed numerical study of the retrogressive failure of landslides in sensitive clays. The dynamic modelling of the landslides is carried out using a novel continuum approach, the particle finite element method, complemented with an elastoviscoplastic constitutive model. The multiwedge failure mode in the collapse is captured successfully, and the multiple retrogressive failures that have been widely observed in landslides in sensitive clays are reproduced with the failure mechanism, the kinematics, and the deposition being discussed in detail. Special attention has been paid to the role of the clay sensitivity on each retrogressive failure as well as on the final retrogression distance and the final run‐out distance via parametric studies. Moreover, the effects of the viscosity of sensitive clays on the failure are also investigated for different clay sensitivities.  相似文献   

Parallelization of the flow-path network model using a particle-set strategy     

Fangli Zhang 《International journal of geographical information science》2019,33(10):1984-2010

High-performance simulation of flow dynamics remains a major challenge in the use of physical-based, fully distributed hydrologic models. Parallel computing has been widely used to overcome efficiency limitation by partitioning a basin into sub-basins and executing calculations among multiple processors. However, existing partition-based parallelization strategies are still hampered by the dependency between inter-connected sub-basins. This study proposed a particle-set strategy to parallelize the flow-path network (FPN) model for achieving higher performance in the simulation of flow dynamics. The FPN model replaced the hydrological calculations on sub-basins with the movements of water packages along the upstream and downstream flow paths. Unlike previous partition-based task decomposition approaches, the proposed particle-set strategy decomposes the computational workload by randomly allocating runoff particles to concurrent computing processors. Simulation experiments of the flow routing process were undertaken to validate the developed particle-set FPN model. The outcomes of hourly outlet discharges were compared with field gauged records, and up to 128 computing processors were tested to explore its speedup capability in parallel computing. The experimental results showed that the proposed framework can achieve similar prediction accuracy and parallel efficiency to that of the Triangulated Irregular Network (TIN)-based Real-Time Integrated Basin Simulator (tRIBS).  相似文献   

基于分布式控制力矩陀螺的水下航行器轨迹跟踪控制   总被引：2，自引：0，他引：2  

黄道敏  徐瑞昆  唐国元  冯雷  刘智  徐国华 《海洋工程》2018,36(6):69-76

基于控制力矩陀螺群(CMGs)的水下航行器具有低速或零速机动的能力。采用基于分布式CMGs的水下航行器方案,并研究其水平面的轨迹跟踪控制问题。通过全局微分同胚变换将非完全对称的动力学模型解耦成标准欠驱动控制模型,并根据简化的模型构建其轨迹跟踪的误差动力学模型,将轨迹跟踪控制问题转化为误差模型镇定问题。基于一种分流神经元模型和反步法设计了系统的轨迹跟踪控制律,该控制器不需要对任何虚拟控制输入进行求导计算,且能确保跟踪误差的最终一致有界性。仿真结果表明该控制器能够实现在不依赖动力学参数先验知识的情况下对光滑轨迹的有效跟踪。  相似文献   

Developing constitutive models from EPR‐based self‐learning finite element analysis          下载免费PDF全文

Ali Nassr  Akbar Javadi  Asaad Faramarzi 《国际地质力学数值与分析法杂志》2018,42(3):401-417

A constitutive model that captures the material behavior under a wide range of loading conditions is essential for simulating complex boundary value problems. In recent years, some attempts have been made to develop constitutive models for finite element analysis using self‐learning simulation (SelfSim). Self‐learning simulation is an inverse analysis technique that extracts material behavior from some boundary measurements (eg, load and displacement). In the heart of the self‐learning framework is a neural network which is used to train and develop a constitutive model that represents the material behavior. It is generally known that neural networks suffer from a number of drawbacks. This paper utilizes evolutionary polynomial regression (EPR) in the framework of SelfSim within an automation process which is coded in Matlab environment. EPR is a hybrid data mining technique that uses a combination of a genetic algorithm and the least square method to search for mathematical equations to represent the behavior of a system. Two strategies of material modeling have been considered in the SelfSim‐based finite element analysis. These include a total stress‐strain strategy applied to analysis of a truss structure using synthetic measurement data and an incremental stress‐strain strategy applied to simulation of triaxial tests using experimental data. The results show that effective and accurate constitutive models can be developed from the proposed EPR‐based self‐learning finite element method. The EPR‐based self‐learning FEM can provide accurate predictions to engineering problems. The main advantages of using EPR over neural network are highlighted.  相似文献